Zebex Z-6070 Series Spezifikationen PDF herunterladen (Seite 18)

4. Wand emulation

To perform Wand Emulation, the scanner can be connected

to a portable data terminal, or a controller that collects the

data as wand data, and interprets it for the host.

1.) Make sure that the power of your computer system is

switched off.

2.) Plug the interface cable modular into the scanner port

until a firm

“Click” sound is heard.

3.) Connect the other end of the interface cable into the

COM port on the PDT or controller.

4.) Use a power +5V DC external power supply to the

power jack on the interface cable if the external power is

required.

5.) Switch on your computer system

6.) Adjust the scanner’s parameters by scanning the

appropriate labels in programming guide, if necessary.

 It is our advice to turn off your POS or host system

before starting the installation of the scanner. By

following this procedure you can avoid from being

electronically damaged to your computer.

 It is also our advice to install the scanner in an

air-circulated place but away from the direct sunlight.

 Use only AC/DC power adaptor approved for the

Z-6070 scanner that ordered from ZEBEX. Usage of

other power supplies may cause damage to the

product, and the damage is not covered by the factory

warranty.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 38 39

Keine Kommentare

Zebex Z-6070 Series Spezifikationen Seite 18